In addition to the usual sources of error (out-of-date libraries, bugs), there are suddenly completely new ones: Have I soldered something wrong? Is it connected incorrectly? Are the LEDs defective?īut it's almost always worth sticking with it, as the moment of success is definitely greater the longer you mull over a problem. But this way I will definitely not repeat my mistakes.ĭebugging hardware is definitely pretty harder than expected. I definitely could have saved a lot of time if I had read the documentation first. And that's all that counts in the end □. The setRingRed function will loop through all the LEDs, will set a new color and will then show it on the ring. After that the loop starts again, so I need to add a second delay. In my case I want to set the whole ring red, wait for 1 second and then turn it off. The setup and the loop functions are used by the board to setup your code and then react to changes. Enter fullscreen mode Exit fullscreen mode
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
March 2023
Categories |